Maxon WL7 Spezifikationen PDF herunterladen (Seite 29)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

PATENTS PENDING

FLOOR POSITION ADJUSTMENT

1. Unfold the platform until the

lights illuminate at ﬂ oor level or

raise the platform to ﬂ oor level

as shown in FIG. 29-1A.

2. Inspect the threshold plate. The

edge of the inboard rollstop should

line up with the edge of the base

plate as shown in FIG. 29-1B.

NOTE: Do this procedure if structure of the Lift is undamaged and:

• Inboard rollstop does not land correctly on the threshold plate when unfold-

ing platform or raising platform to ﬂ oor level.

• The angle position sensor (ILAPS) is replaced.

• The controller is replaced.

The adjustment is done correctly if:

• Inboard rollstop rests on threshold plate and lines up approximately with

edge of base plate.

If the Lift requires frequent FLOOR POSITION ADJUSTMENT, replace the

angle position sensor (ILAPS).

EDGE OF

INBOARD

ROLLSTOP

INBOARD ROLLSTOP LINES

UP WITH BASE PLATE

FIG. 29-1B

PLATFORM AT FLOOR LEVEL

(LH SIDE SHOWN)

FIG. 29-1A

THRESHOLD

PLATE

EDGE OF

BASE PLATE

PLATFORM

LIGHT

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 90 91

Keine Kommentare

Maxon WL7 Spezifikationen Seite 29