Maxon WL7 Spezifikationen PDF herunterladen (Seite 20)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

PATENTS PENDING

PLATFORM TILT ADJUSTMENT

NOTE: Do this procedure if structure of the Lift is undamaged and:

• Outboard rollstop will not open completely when platform reaches the

ground.

• Bottoms of the vertical arms touch the ground before outboard rollstop.

• Platform is sloped down excessively toward the outboard rollstop.

The adjustment is done correctly if:

• Outboard rollstop opens completely when platform reaches the ground.

• Outboard rollstop will touch the ground before bottoms of vertical arms.

• Platform will slope down a little toward the outboard rollstop.

1. Make sure power switch

(FIG. 20-1) is turned

on. Lower the platform

and stop approximately 4”

above ground.

NOTE: The platform tilt adjustment is important for operation of the outboard roll-

stop and for keeping platform level when it reaches the ground. Vehicle ﬂ oor

height, Lift installation angle, and stiffness of the vehicle suspension may

change the angle of platform on the ground.

PLATFORM LOWERED TO GROUND LEVEL

FIG. 20-1

PLATFORM

POWER

SWITCH

GROUND

LEVEL

4”

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 90 91

Keine Kommentare

Maxon WL7 Spezifikationen Seite 20