Maxon WL7-vers. C Betreibershandbuch PDF herunterladen (Seite 31)

PATENTS PENDING

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

Never route an energized wire. Make sure the battery is disconnected. Always

route electrical wire clear of any moving parts, brake lines, sharp edges, and ex-

haust systems. Never route power cable next to a wiring harness on the vehicle.

Do not loop excess cable. Cut the cable to ﬁ t and leave slack. Attach securely.

If drilling is necessary, be sure to check underside of vehicle before drilling so

you do not damage any fuel lines, vent lines, brake lines or wires. When routing

electrical wire through a hole in vehicle ﬂ oor, use supplied grommet to protect

wires from chaﬁ ng.

CAUTION

ROUTE/CONNECT CABLES & HAND PENDANT

1. Locate and drill a 1-5/16” hole through the

vehicle ﬂ oor (FIG. 31-1). Drill the hole in a

location that will be hidden by the pump

cover and that will allow power cable to

be routed to dc relay (FIG. 31-1). Since

the interlock system wiring from the Lift

also branches out in that area, locate the

hole so the 3-conductor Interlock system

cable can be routed from the Lift through

the vehicle ﬂ oor to the vehicle safety inter-

lock. Install the plastic grommet (FIG.

31-1) on the vehicle ﬂ oor with 2 of the #12

self-drilling screws.

2. Route the long power cable (Kit item)

from main circuit breaker (FIG. 31-2),

underneath vehicle ﬂ oor to dc relay (FIG.

31-1).

FIG. 31-1

3. Secure power cable every 8”-10”.

SELF-TAPPING

SCREWS

GROMMET

LONG

POWER

CABLE

90 AMP MAIN

CIRCUIT BREAKER

FIG. 31-2

LONG POWER

CABLE

DC RELAY

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 73 74

Keine Kommentare

Maxon WL7-vers. C Betreibershandbuch Seite 31